ZyXEL 202H 91-003-194003B User Manual

P-202H Plus v2 User’s Guide

Chapter 20 Remote Node Configuration

192

A typical LAN-to-LAN application is to use your ZyXEL Device to connect a branch office to 
the headquarters, as depicted in the following diagram.

Figure 91   TCP/IP LAN-to-LAN Application

For the branch office, you need to configure a remote node in order to dial out to headquarters.

Max Trans Rate 

(Kbps)

Enter the maximum data transfer rate allowed for this remote node. This 

parameter is in kilobits per second.

Target Utility 

(Kbps)

Enter the two thresholds separated by a “-” for subtracting and adding the second 

port.

Add Persist

This parameter specifies the number of seconds where traffic is above the adding 

threshold before the ZyXEL Device will bring up the second link.

Subtract Persist

This parameter specifies the number of seconds where traffic is below the 

subtraction threshold before your ZyXEL Device drops the second link.

Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to 

save your configuration, or press [ESC] at any time to cancel.

Table 66   Menu 11.2 Remote Node PPP Options