ZyXEL 202H 91-003-194003B User Manual

P-202H Plus v2 User’s Guide

203

Chapter 22 Dial-in Setup

From the Main Menu, enter 13 to go to Menu 13 - Default Dial-in Setup. This section 
describes how to configure the protocol-independent fields in this menu. For the protocol-
dependent fields, refer to the appropriate chapters.

Figure 97   Menu 13 Default Dial-in Setup

The following table describes the fields in this menu.

                Menu 13 - Default Dial-in Setup

 Telco Options:                       IP Address Supplied By:
   CLID Authen= None                    Dial-in User= Yes
                                        IP Pool= No
 PPP Options:                             IP Start Addr= N/A
   Recv Authen= CHAP/PAP                  IP Count(1,4)= N/A
   Compression= Yes
   Mutual Authen= No                  Session Options:
   O/G Username=                        Edit Filter Sets= No
   O/G Password= ********
   Multiple Link Options:
     Max Trans Rate(Kbps)= 128

 Callback Budget Management:
   Allocated Budget(min)=
   Period(hr)=

                Press ENTER to Confirm or ESC to Cancel:

Table 71   Menu 13 Default Dial-in Setup

Telco Options:

CLID Authen

This field sets the CLID authentication parameter for all incoming calls. There are 

three options for this field:
None - No CLID is required.
Required - CLID must be available, or the ZyXEL Device will not answer the call.
Preferred - If the CLID is available then CLID will be used; otherwise, 

authentication is performed in PPP negotiation.

PPP Options:

Recv Authen

This field sets the authentication protocol for incoming calls. For security reason, 

setting authentication to None is strongly discouraged. Options for this field are:
CHAP/PAP - Your ZyXEL Device will try CHAP first, but PAP will be used if CHAP 

is not available.
CHAP -Use CHAP only.
PAP - Use PAP only.
None - Your ZyXEL Device tries to acquire CHAP/PAP first, but no authentication 

is required if CHAP/PAP is not available.