WatchGuard Ethernet Power Injector WG8568 User Manual
Product codes
WG8568
13
Device Connections and Buttons
Ethernet Network Interface
Standard RJ45 connector that supports link speeds of 10/100/1000 Mbps.
Power Input
A 12V AC adapter is included with your device. Connect the AC adapter to the
device and to a power source. Use only the supplied AC power adapter.
device and to a power source. Use only the supplied AC power adapter.
If you use the optional PoE adapter, make sure that the PoE adapter complies with
the IEEE 802.3af PoE specification. Do not use any PoE adapters that are not
IEEE 802.3af compliant as they may damage your device.
the IEEE 802.3af PoE specification. Do not use any PoE adapters that are not
IEEE 802.3af compliant as they may damage your device.
Reset Button
To reset the WatchGuard AP device to factory default settings, disconnect the
power from the device. Press and hold the Reset button while you reconnect power
to the device. Continue to hold the Reset button for at least ten seconds while the
device initializes. When the device completes its initialization, it will be reset to
factory default settings.
power from the device. Press and hold the Reset button while you reconnect power
to the device. Continue to hold the Reset button for at least ten seconds while the
device initializes. When the device completes its initialization, it will be reset to
factory default settings.
If you reset the WatchGuard AP to factory settings, you must perform the pairing
procedure again to pair the AP device with the XTM device.
procedure again to pair the AP device with the XTM device.