WatchGuard Ethernet Power Injector WG8568 User Manual

1. Position the mounting bracket on the wall or ceiling where you want to install the 

WatchGuard AP device.

2. Use the mounting bracket as a guide to mark the position of the WatchGuard AP 

device on the wall or ceiling.

3. Remove the mounting bracket and insert the large mounting screws into the marks 

you made on the ceiling or wall.

4. Insert the long 5x32 screws through the bracket and into the mounting screws.

5. Insert the short 6x12 screws partway into the bottom of the device. Do not tighten 

the screws completely. Keep the heads of the screws exposed to attach the device 
to the mounting bracket.

If extra space is required between the device and the mounting bracket, use the 
spacers and long 6x25 screws from the T-rail mounting hardware kit.

6. To attach the device to the mounting bracket, insert the screw heads from the device 

into the slots in the mounting bracket, and rotate the device clockwise to lock the 
device in place.