Zebra HW46211 User Manual

Page 4-22

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Install the Main Logic Board 

1. Refer to 

. Reinstall the two standoffs into the main logic board.

2. Install the main logic board using the screw and nut previously removed.

3. Refer to 

. Reinstall the screws and studs for the serial and parallel 

interface connectors.

4. Reinstall the PCMCIA board by pushing it onto the two standoffs and into 

connectors P23 and P24, securing it with the previously removed screw.

5. Refer to 

. Reconnect all ribbon and small wire connections to the main 

logic board.

6. Reinstall the memory or font card into the PCMCIA board and reinstall the shield.

7. Reinstall any other option boards previously removed.

8. Reinstall the electronics cover.

9. Reinstall the AC power cord and restore power.

10. Turn the printer On (l) and verify operation.

11. Turn the printer Off (O).

12. Press and hold the Left Black Oval while turning the printer On (l), hold the Left 

Black Oval until all front panel lights come on.

13. Press NEXT/SAVE until MODEL SELECT appears.

14. Press the Left Black Oval or the Right Black Oval until you model appears.