Zebra HW46211 User Manual

Page 4-28

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

RRP No. 8: Remove and Install the Rewind Drive Belt 

Remove the Rewind Drive Belt 

1. Refer to 

. Turn the printer Off (O) and disconnect the AC 

power cord and data cables.

2. Open the media cover.

3. Open the printhead and remove the media and ribbon. Close the printhead.

4. Refer to 

 and remove the electronics cover.

5. Refer to 

 and remove the main drive belt.

6. Refer to 

 and remove the power supply.

7. Refer to 

 and locate the idler pulley. On the media side of the printer, 

remove the plug from the lower access hole in the side plate. Loosen the idler pulley 
mounting screw.

8. Slide the idler pulley assembly toward the front of the printer to relieve tension on 

the rewind drive belt.

9. Remove the rewind drive belt.

Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.

This installation must be performed by a qualified service technician.

Idler

Gear

Rewind Drive Belt

Rewind Platen Pulley

Media Take-Up

Pulley

Stepper Motor

Pulley