Zebra HW46211 User Manual
Page 4-44
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Replace the Platen Roller
Remove the Upper Platen Roller
1. Refer to
. Turn the printer Off (O), remove the AC power
cord and data cables.
2. Open the media cover and printhead; remove media and ribbon. Close the printhead.
3. Refer to
3. Refer to
and remove the electronics cover.
4. Refer to
5. Refer to
and loosen but do not remove the set screws in the platen
pulley.
Figure 4-26. Platen Roller Removal
6. Remove the platen pulley and spacer.
7. When facing the front of the printer, slide the platen roller to the right. Remove the
7. When facing the front of the printer, slide the platen roller to the right. Remove the
C-clips, washer, and right bearing from the platen roller.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
Wear protective eyewear when removing E-rings, C-clips, snap rings, and
springs. All of these are under tension and could fly off while being removed.
springs. All of these are under tension and could fly off while being removed.
Caution:
This installation must be performed by a qualified service technician.
C-Clip
Peel/Tear-Off Bar
Peel/Tear-Off Bar
Mounting Screw
Mounting Screw
Platen Roller
Platen Pulley
Mark with label/tape
top and right side.
top and right side.
Bearing
Bearing
Washer
Large Spacer