Zebra HW46211 User Manual

Page 4-50

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Replace the Platen Pulley 

4. Refer to 

. Turn the printer Off (O), remove the AC power 

cord and data cables.

5. Refer to 

 and remove the electronics cover.

6. Refer to 

 and remove the main drive belt.

Remove and Install the Upper Platen Pulley 

1. Refer to 

. Loosen the two set screws. Remove the old pulley assembly.

2. Install a new platen pulley on shaft aligning the set screws with the flats of the 

platen shaft.

3. Tighten the set screws.

4. Reinstall and adjust the tension of main drive belt.

5. Reinstall electronics cover.

6. Reconnect data cables and AC power cord.

7. Turn the printer On (l).

Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.

This installation must be performed by a qualified service technician.

Main Drive Belt

Stepper
Motor
Pulley

Platen Pulley
Assembly

Inside Peel/Tear-Off Bar
Mounting Screw

Ribbon Take-Up
Pulley

Set Screws