Zebra HW46211 User Manual

Page 4-66

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

7. Refer to 

. Locate the electrical leads from the two sensors. Open the 

cable clamps and follow the sensor leads to the main logic board connectors. 

8. Remove these connectors.

9. From the media side of the printer, remove the grommet from the slot in the printer 

main frame. Gently pull the sensors while guiding the wires through the hole in the 
main frame.

10. Remove the upper and lower sensors.

Install the Sensor 

1. Refer to 

. Guide the wires of the new upper and lower media sensors 

through the main frame and install the split grommet into the main frame.

2. Connect the leads of the sensors to the main logic board, P-8 and P-10.

3. Reinstall the upper sensor bracket and secure it with thumbscrews.

4. Refer to 

. Reinstall the pivot pin and dancer spring.

5. Refer to 

. Slightly spread the lower media bracket open and install the 

lower media sensor.

6. On the electronics side of the printer, route the electrical leads through the cable 

clamps and reinstall a new cable tie.

7. Resecure cable clamps with the nuts.

8. Reinstall the electronics cover.

9. Refer to 

 and adjust the position of the sensors.

10. Reinstall the media and ribbon and close the media cover.

11. Reconnect the data cables and the AC power cord.

12. Turn the printer On (l).

Lower

Media Sensor

Grommet