Zebra HW46211 User Manual

Page of 275
Page 4-84
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A  1/24/06
Section 4
Maintenance
Options
Install Options 
Supply Spindle 
1. Refer to 
. Turn the printer Off (O) and remove the AC 
power cord and communication cables.
2. Refer to 
 and remove the electronics cover.
. Remove the font card or memory card from the card slot at the 
rear of the printer by removing the option card shield and pressing the card-release 
button.
4. Refer to 
. Remove any optional interface board 
installed.
5. Refer to 
. Disconnect all ribbon cable and small wire 
connectors from the main logic board, and remove it.
6. Refer to 
. Remove the media hanger mounting screw and washer.
7. Remove the media hanger by lifting it straight up then out from the printer frame.
Figure 4-57.   Remove Hanger and Install Spindle
8. Install the media supply spindle with support between the shaft and the printer 
frame.
9. Install the screw and washer onto the end of the spindle shaft and tighten.
10. Reinstall the main logic board mounting plate.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Mounting Screw
Washer
Support
Mounting Screw
Washer
Spindle
Assembly
Hanger