Zebra HW46211 User Manual

Page 4-92

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

Install the Take-Label Sensors

(Do not install on cutter units.)

The Take-Label Sensors are required only in Peel-Off Mode.

Refer to 

.

1. Remove the upper and lower take-label sensor cover plates by removing the two 

socket head cap screws with the Allen wrench.

2. Insert the upper take-label sensor assembly (18) (green/yellow wires), connector, 

and cable through the upper take-label sensor hole in the main frame.

3. Position the sensor with the window facing directly down and use one (19) screw to 

fasten the sensor in place.

4. Insert the lower take-label sensor assembly (18) (red/black wires), connector, and 

cable through the lower take-label sensor hole in the main frame.

5. Position the sensor with the window facing directly up and use one (19) screw to 

fasten the sensor in place.

6. Route the wires through the cable clamps and toward the main logic board, ensuring 

the wires do not come in contact with any moving parts.

7. Refer to 

. Connect the upper take-label sensor connector to P2 on the 

main logic board and the lower take-label sensor connector to P1.

8. Reinstall the power supply assembly.

9. Reinstall the electronics cover.

Lower

Take-Label

Sensor (P1)

Upper

Sensor (P2)

Take-Label

P6

P25

P27

P8

P2

P1

P3

P32

P31

P19

P5

P10

Note • When in Peel-Off Mode, if the two sensors are not aligned with each 
other, the Take-Label LED lights up and the printer does not operate.