Zebra HW46211 User Manual
Page 4-114
110XiIIIPlus Maintenance Manual
13185L-002 Rev. A 1/24/06
Section 4
Maintenance
Figure 4-75. PCB Location and Interconnections
Disassemble the Printer
The printer must be partially disassembled to install the parts in this kit.
1. Refer to
. Turn the printer Off (O) and remove the power
cord. Disconnect the printer communications cable.
2. Refer to
and remove the electronics cover.
3. Refer to
. Note and remove all connectors from the AC/DC
power supply assembly.
Cutter
Option
Front Panel
Interface
LCD
Display
Lower
Media Sensor
Ribbon
Sensor
Sensor
Head-Open
Sensor
Printhead
Data
Black-Mark
Sensor
Lower
Take-Label
Sensor
Upper
Take-Label
Sensor
Upper
Media Sensor
Stepper
Motor
Main Logic
PCB
PCMCIA
Option Board
AC/DC
Power
PCB
Printhead
Power
AC
Input
AC
Power
Fuse
Main Logic
Board
Power
Cutter
Option
P6
P25
P27
P8
P2
P1
P3
P32
P31
P19
P5
P10
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.