Zebra HW46211 User Manual

13185L-002 Rev. A  1/24/06

110XiIIIPlus Maintenance Manual

Page 4-117

Maintenance

Section 4

4. Loosely attach the upper bracket to the side plate with two screws (9).

5. Align the slots in the lower cutter bracket with the threaded holes in the main frame 

and loosely attach the bracket with two screws (9).

6. Refer to 

. Open the printhead and observe the position of the tear-off bar 

(in front of the platen roller) and the rear cutter blade. Align the rear cutter blade 
parallel to the outer edge of the tear-off bar across the entire width of the media path. 
The cutter mechanism must be positioned as far forward as possible while 
maintaining parallelism with the tear-off bar. This should prevent interference of the 
rear cutter blade with the tear-off bar. Tighten all mounting screws.

Lower

Drive

Arm

Long Drive

Link

Slotted

Link

Grease

Sensor Mounting

Post

16

15

2

1

3

4

6

5

7

14

11

HEAD

OPEN

CLOSED

Rotary Cutter Blade

Upper Cutter Bracket

Mounting Screw

Media Guide

0.100 in.
(2.5 mm)

Ensure the top of the tear-off
bar is positioned above or
level with the top of the
rear cutter blade.

Tear-Off
Bar

Clearance of 0.030 in. (0.7 mm)
minimum between rear cutter blade
and tear-off bar

Screws control position
of cutter module and
squareness to media.

Rear Cutter
Blade

Relative position of the rotary cutter blade when the drive link assembly
is stopped by the optical sensor, when the power is On ( ) in Cutter Mode.