Zebra HW46211 User Manual

Page 2-10

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A 1/24/06

Section 2

Operations Overview

Peel-Off Mode

Refer to 

1. Remove the rewind plate from the front of the printer. Store it on the two mounting 

screws on the inside of the front panel.

2. Open the printhead.

3. Slide the media guide and media supply guide as far away from the printer frame as 

possible. Flip down the media supply guide.

4. Load media as shown.

5. When loading media, allow approximately 36 in. (900 mm) of media to extend past 

the tear-off/peel-off bar. Remove all labels from this portion to create a leader.

6. Remove the hook from the rewind spindle. If you are using a core, slide it onto the 

rewind spindle until it is flush against the guide plate.

7. Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle, and 

reinstall the hook.

8. Flip up the media supply guide. Slide in the media guide and media supply guide so 

they just touch, but do not restrict, the edge of the roll.

Before closing the printhead, ensure that:

•

The media is positioned against the inside guides.

•

The media is taut and parallel with itself and the pathway when wound onto the 
rewind spindle/core.

9. Close the printhead.

To remove the used liner, refer to 

Note • Rewind option required.

Media

Guide

Media

Media

Supply

Guide

Closed

Open

Rewind
Spindle

Hook

Printhead Lever

Rewind

Plate

Tear-off/

Peel-off

Bar

Guide

Plate

Label

Label

Liner