Zebra HW46211 User Manual

13185L-002 Rev. A 1/24/06

110XiIIIPlus Maintenance Manual

Page 2-11

Operations Overview

Section 2

Rewind Mode (without cutter option)

Refer to 

1. Remove the rewind plate from its storage location in front of the print mechanism 

inside the media compartment.

2. Invert the rewind plate so the lip on the attached hook plate points down.

3. Insert the hook plate lip approximately 1/2 in. (13 mm) into the lower opening in the 

side plate.

4. Align the upper end of the rewind plate with the corresponding opening in the side 

plate. Slide in the rewind plate so it stops against the printer’s main frame.

5. Open the printhead.

6. Slide the media guide and media supply guide as far away from the printer frame as 

possible. Flip down the media supply guide.

7. Load media as shown.

8. When loading media, allow approximately 36 in. (91 cm) of media to extend past 

the printhead.

9. Remove the hook from the rewind spindle. If you are using a core, slide it onto the 

rewind spindle until it is flush against the guide plate.

10. Wind the liner around either the 3 in. (76 mm) core or the rewind spindle and 

reinstall the hook.

11. Flip up the media supply guide. Slide in the media guide and media supply guide so 

they just touch, but do not restrict, the edge of the roll.

Before closing the printhead, ensure that:

•

The media is positioned against the inside guides.

•

The media is taut and parallel with itself and the pathway when wound onto the 
rewind spindle/core.

12. Close the printhead.

Note • Rewind option required.