ZyXEL P-2601HN-F3 91-006-141001B User Manual

5.  POWER: Use the power adaptor provided to connect an appropriate 

power source to this socket.

6.  Push the power button to the ON position.

Look at the LEDs (lights) on the top panel of the P-2601HN(L)-F1 Series.

•  The WIRELESS light stays green when the wireless LAN is ready. It 

blinks when the P-2601HN(L)-F1 Series is sending/receiving data 
through the wireless LAN. 

•  The POWER light blinks during start-up and is green once the P-

2601HN(L)-F1 Series is ready.

•  The ETHERNET light turns on if the corresponding ETHERNET 

port is properly connected. If you do not connect a computer 
correctly to this port, the ETHERNET light will not turn on.

The ETHERNET and/or WIRELESS lights blink when the P-2601HN(L)-
F1 Series is sending or receiving data. If the POWER light does not turn 
on during start up, try turning the P-2601HN(L)-F1 Series off, check the 
connections, wait a few seconds and then turn it back on. If the problem 
persists, you may have a hardware problem and you need to contact 
your vendor.

•  The PHONE light stays on when your SIP account is registered and  

blinks if the receiver is off the hook. See 

 on 

page 

 to see how to make calls through the Internet.