Cisco TRC5 CTS-RMT-TRC5= User Manual
Product codes
CTS-RMT-TRC5=
8
Deployment Details
August 2012 Series
8
Step 8:
At the prompt, run the install wizard.
Run install wizard [n]:
y
For security reasons, you are advised to change the admin pass-
word from the default of TANDBERG when using the install wizard.
word from the default of TANDBERG when using the install wizard.
Tech Tip
Step 9:
Follow the prompts to specify the settings.
Do you wish to change the system password? [n]:
y
Password for your admin account:
[password]
Type the password again:
[password]
Whether you want to use IPv4, IPv6 or Both:
IPV4
The LAN 1 IP address:
10.4.48.130
The LAN 1 IPv4 subnet mask:
255.255.255.0
The IP default gateway:
10.4.48.1
The Ethernet speed:
auto
Whether you want to use SSH:
y
Whether you want to use Telnet:
n
After the install wizard is finished, you are prompted to log in again.
Step 10:
Log in with the username
admin
and the new
[password]
.
Step 11:
When you see the install wizard prompt again, enter
n
to skip the
wizard.
Step 12:
Restart the system in order for the new settings take effect (required).
xCommand restart
For security reasons, you are advised to change the root pass-
word from the default of TANDBERG.
word from the default of TANDBERG.
Tech Tip
After the system restarts, log in as
root
to change the password for the root
account.
Step 13:
Log in again with the username
root
.
Step 14:
Enter the default root password
TANDBERG
.
Step 15:
After logging in, type the
passwd
command.
Step 16:
Enter the new password
[password]
.
Step 17:
When prompted, retype the password
[password]
.
Step 18:
Type the
exit
command. This logs you out of the root account.
Step 19:
Disconnect the serial cable and store it in a safe place.
Procedure 3
Configure the Cisco VCS
The rest of the configuration of the Cisco VCS is done using a standard web
browser. You use the information collected in Table 1 at the beginning of this
Cisco VCS configuration process to fill in the fields. This is the information
you need to configure a basic VCS system for use with SIP endpoints.
browser. You use the information collected in Table 1 at the beginning of this
Cisco VCS configuration process to fill in the fields. This is the information
you need to configure a basic VCS system for use with SIP endpoints.
Step 1:
Open a browser window, and type the IP address of Cisco VCS:
10.4.48.130
Step 2:
Select
Administrator login
, enter the following values, and then
click
Login
:
• Username—
admin
• Password—
[password]
Step 3:
Navigate to
System > System
, in the
System name
box, enter
VCSc1
,
and
then
click
Save
.