Cisco TRC5 CTS-RMT-TRC5= User Manual
Product codes
CTS-RMT-TRC5=
27
Deployment Details
August 2012 Series
27
Configuring Cisco TelePresence System Profile Series
Process
The recommended Cisco TelePresence System Profile Series endpoints are
multipurpose room systems that you can configure using SIP. The configura-
tion steps for this platform are the same as they are for any of the Cisco
TelePresence System Codec C-Series endpoints. Before getting started,
you need to collect certain information specific to your site. You can fill in
the following table.
multipurpose room systems that you can configure using SIP. The configura-
tion steps for this platform are the same as they are for any of the Cisco
TelePresence System Codec C-Series endpoints. Before getting started,
you need to collect certain information specific to your site. You can fill in
the following table.
Table 4 - Information you need before configuring SIP endpoints
Item
Cisco SBA
configuration
configuration
Site-specific
details
details
System name
85104600@cisco.local
DNS server address
10.4.48.10
DNS domain name
cisco.local
SNMP community name
cisco
NTP server address
10.4.48.17
Time zone
GMT -8 (Pacific)
SIP URI
85104600@cisco.local
SIP Proxy 1 address
10.4.48.130
SIP Proxy 2 address
10.4.48.131
Procedure 1
Configure Profile connectivity to the LAN
To ensure that video traffic is prioritized appropriately, you must configure
the Catalyst access switch port where the video endpoint is connected to
trust the DSCP markings. The easiest way to do this is to clear the interface
of any previous configuration and then, apply the egress QoS macro that
was defined in the access-switch platform configuration of the SBA—LAN
the Catalyst access switch port where the video endpoint is connected to
trust the DSCP markings. The easiest way to do this is to clear the interface
of any previous configuration and then, apply the egress QoS macro that
was defined in the access-switch platform configuration of the SBA—LAN
Deployment Guide.
Step 1:
Login to the Catalyst switch with a username that has the ability to
make configuration changes.
Step 2:
Clear the interface’s configuration on the switch port where the
video endpoint is connected.
default interface
GigabitEthernet1/0/23
Step 3:
Configure the port as an access port and apply the Egress QoS
policy.
interface
GigabitEthernet1/0/23
description Profile 42
switchport access vlan
64
switchport host
macro apply EgressQoS
Procedure 2
Configure the Profile series platform
The endpoint uses the Dynamic Host Configuration Protocol (DHCP) to
automatically obtain its IP address from the network services layer of the
Cisco SBA platform. The configuration of the SIP endpoint is done with the
remote control.
automatically obtain its IP address from the network services layer of the
Cisco SBA platform. The configuration of the SIP endpoint is done with the
remote control.
Using the remote control, the following steps allow you to verify the end-
point is getting the correct IP information from the server. You also need to
manually set the time to allow the NTP service to take over after it is properly
configured.
point is getting the correct IP information from the server. You also need to
manually set the time to allow the NTP service to take over after it is properly
configured.
Step 1:
Connect all of the cables as specified in the endpoint installation
guide, and turn on the power switch. Wait several minutes for the system to
power up.
power up.