Epson EH-TW8100 V11H524070LW User Manual
Product codes
V11H524070LW
Troubleshooting
79
Problem Solving
Reading the Indicators
You can check the status of the projector from the flashing and lit
,
t
(operation indicators),
o
and
m
on
the control panel.
Refer to the following table to check the projector's status and how to remedy problems shown by the
indicators.
indicators.
Indicator status during an error/warning
: Lit
: Flashing
: Off
Indicators
Status
Remedy
(orange)
Replace Lamp
It is time to replace your lamp. Replace the lamp with a new lamp
as soon as possible.
as soon as possible.
s
The lamp may explode if you continue to use it in this status.
(orange)
High Temp Warning
You can continue projecting. If the temperature rises too high
again, projection stops automatically.
again, projection stops automatically.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it.
s
(red)
Internal Error
The projector has malfunctioned.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
Remove the power plug from the electrical outlet, and contact
your local dealer or the nearest Epson repair center.
s
(red)
Fan Error
Sensor Error