Epson EH-TW8100 V11H524070LW User Manual
Product codes
V11H524070LW
Troubleshooting
84
Check
Remedy
Has condensation formed on the lens?
If the projector is suddenly taken from a cold environment to a
warm environment, or if sudden ambient temperature changes
occur, condensation may form on the surface of the lens, and this
may cause the images to appear fuzzy. Set the projector up in
the room about one hour before it is used. If the projector is wet
from condensation, turn off the projector, disconnect the power
cable, and leave it for a while.
warm environment, or if sudden ambient temperature changes
occur, condensation may form on the surface of the lens, and this
may cause the images to appear fuzzy. Set the projector up in
the room about one hour before it is used. If the projector is wet
from condensation, turn off the projector, disconnect the power
cable, and leave it for a while.
Interference or distortion appear in images
Check
Remedy
Is the image signal format setting correct?
When Video is input
If nothing is projected even when Video Signal is set to Auto
from the configuration menu, set the signal that matches the
connected device.
If nothing is projected even when Video Signal is set to Auto
from the configuration menu, set the signal that matches the
connected device.
s
Extended - Input Signal - Video Sig-
When Component is input
If nothing is projected even when Component is set to Auto
from the configuration menu, set the signal that matches the
connected device.
If nothing is projected even when Component is set to Auto
from the configuration menu, set the signal that matches the
connected device.
s
Extended - Input Signal - Compo-
nent
Are the cables connected correctly?
Check that all the cables required for projection are securely
connected.
connected.
s
Is an extension cable being used?
If an extension cable is used, electrical interference may affect
the signals.
the signals.
(Only when projecting computer image sig-
nals)
nals)
Are the Sync. and Tracking settings adjusted
correctly?
correctly?
The projector uses automatic adjustment functions to project at
the optimum status. However, depending on the signal, some
may not be adjusted correctly even after performing self correc-
tions. If this happens, adjust the Tracking and Sync. settings
from the configuration menu.
the optimum status. However, depending on the signal, some
may not be adjusted correctly even after performing self correc-
tions. If this happens, adjust the Tracking and Sync. settings
from the configuration menu.
s
(Only when projecting computer image sig-
nals)
nals)
Is the correct resolution selected?
Set the computer so that the signals being output are compatible
with the projector.
with the projector.
s
Part of the image is truncated (large) or small
Check
Remedy
Is the correct Aspect selected?
Press the
button, and then select the Aspect that match-
es the input signal.
s
Signal - Aspect
When subtitled images are being projected during Zoom, adjust
the Zoom Caption Pos. setting from the configuration menu.
the Zoom Caption Pos. setting from the configuration menu.
s
Is the image Position adjusted correctly?
Adjust the Position setting from the configuration menu.
s
Signal - Position
(Only when projecting computer image sig-
nals)
nals)
Is the correct resolution selected?
Set the computer so that the signals being output are compatible
with the projector.
with the projector.
s