Panasonic DMW-MCFT5E User Manual

Page of 160
(ENG) VQT4V83
21
Thoroughly wash any grease on your hands.
Do not allow the grease on your hands to come into contact with your mouth or 
eyes.
If water leaks into the case, stop using it immediately.
This may cause an electric shock, burning or a fire.
Consult your dealer.
If anything abnormal occurs while using the Case underwater, please follow 
all necessary procedures and guidelines for decompressing when you 
ascend.
If you ascend too quickly, you may get caisson disease.
If smoke or abnormal heat, smells or sounds come from the Case, stop using 
it immediately.
These may cause an electric shock, burning or fire.
Remove the digital camera from the Case and then immediately remove the 
battery from the digital camera.
Consult your dealer.
Be careful when opening the Case after water leakage.
The leaked water may blow out or the rear case may flip.
Do not leave the Case where the temperature is high.
The temperature inside the Case becomes very high particularly when it is 
exposed to direct sunlight on a beach, a ship etc. or when it is left in an airtight 
car in the summer. The heat may damage the Case or its inner parts.
If a digital camera is attached to the Case, it may also be damaged.
If you use the attached digital camera when the temperature inside the Case is 
very high, it may cause leakage, short-circuiting or insulation failure resulting in 
fire or malfunction.
Do not handle the digital camera or the battery with wet hands.
This may cause an electric shock or malfunction.
∫ When taking pictures with the flash
When taking pictures with the flash, the corners of the picture may be vignetted or 
the picture may not be lit evenly.
When taking pictures with the flash, the available flash range is less underwater 
than on land.
Caution for Use
∫ Handling of the O-ring
Do not use alcohol, thinner or a chemical cleaning agent for cleaning the O-
ring. This will cause damage to, or deterioration of, the O-ring.
If you will not be using the Case for a long period of time, remove the O-ring 
from the O-ring groove, apply a thin coat of grease (supplied), place it in a 
polyester bag and then store it in a cool, dark place to prevent the surface 
from being damaged. When you use the O-ring again, thoroughly check that 
it is not scratched, damaged or split.
DMW-MCFT5_PP&E-VQT4V83.book  21 ページ  2013年1月16日 水曜日 午前11時35分