IBM Flex System V7000 Expansion Enclosure 4939H29 User Manual
Product codes
4939H29
8068ch05-GUI.fm
Draft Document for Review January 29, 2013 12:52 pm
188
IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 5-16 System Details - Canisters
In the Figure 5-16, the SAS Port 1 is Offline as the control enclosure is not currently
connected to any disk enclosures.
connected to any disk enclosures.
Figure 5-17 on page 189 shows the bottom section of the properties for the left Canister
where World Wide Names (WWN) can be reviewed. The WWNs are used when the IBM Flex
System V7000 Storage Node connects to an external Fibre Channel attached storage system
through SAN switches. For these SAN switches appropriate SAN switch zoning must be
applied for the external system to communicate with the IBM Flex System V7000 Storage
Node.
where World Wide Names (WWN) can be reviewed. The WWNs are used when the IBM Flex
System V7000 Storage Node connects to an external Fibre Channel attached storage system
through SAN switches. For these SAN switches appropriate SAN switch zoning must be
applied for the external system to communicate with the IBM Flex System V7000 Storage
Node.
For more information about SAN zoning for the IBM Flex System V7000 Storage Node check
Chapter 11, “SAN Connections and Configuration” on page 431.
Chapter 11, “SAN Connections and Configuration” on page 431.
For more information about SAN zoning with IBM/Brocade switches refer to Implementing an
IBM b-type SAN with 8 Gbps Directors and Switches, SG24-6116.
IBM b-type SAN with 8 Gbps Directors and Switches, SG24-6116.