StarTech.com S-Video Video Extender over Cat 5 with Audio SVIDUTPEXTA Leaflet
Product codes
SVIDUTPEXTA
Introduction
Thank you for purchasing a StarTech.com S-Video and
Audio over Cat5 Extender. This product offers a cost effec-
tive way to connect S-Video devices and RCA component
audio using Cat5 cable.
Audio over Cat5 Extender. This product offers a cost effec-
tive way to connect S-Video devices and RCA component
audio using Cat5 cable.
Features
• Extend S-Video signals up to 200 meters
• No software or power adapter required
• Works with Shielded Twisted Pair (STP) and
Untwisted Pair (UTP cable)
Before You Begin
System Requirements
• An S-Video video Source
• An RCA component audio source
• Input and Output S-Video cables
• Input and Output RCA component audio cables
• A display with an available S-Video input
Contents
2 x S-Video Extenders (local and remote ends)
1 x 20cm S-Video cable
1 x Installation/Mounting Kit
1 x User Manual
Basic Setup
1. Connect the S-Video cable to the output on the back of
the audio/video source.
2. Connect the opposite end of the S-Video cable used in
Step 1 to the SVIDUTPEXT local unit (marked VIDEO).
3. Connect an audio RCA component cable to the output
ports located on the audio/video source.
4. Connect the opposite end of the component audio cable
to the audio ports on the local SVIDUTPEXT unit
(marked as L - Audio - R).
(marked as L - Audio - R).
5. Connect the Cat5 cable to the RJ45 port on the local
SVIDUTPEXT unit.
6. Connect the opposite end of the Cat5 cable to the
RJ45 port on the remote SVIDUTPEXT unit.
7. Connect a second S-Video cable to the designated port
on the remote SVIDUTPEXT unit (marked VIDEO).
8. Connect the remaining end of the second S-Video cable
to the monitor/display. For further instructions on how to
locate the S-Video port, please refer to the
documentation that accompanied the display at the time
of purchase.
locate the S-Video port, please refer to the
documentation that accompanied the display at the time
of purchase.
9. Connect an audio RCA component cable to the audio
ports located on the remote SVIDUTPEXT unit.
10.Connect the opposite end of the component audio cable
to the audio output ports located on the audio output
device (i.e. Stereo receiver, television etc.)
device (i.e. Stereo receiver, television etc.)
Specifications
General specifications
Accessories
ZENSVID1
Cable ZEN 3.3 ft (1m) S-Video Cable
Cable ZEN 3.3 ft (1m) S-Video Cable
ZENSVID2
Cable ZEN 6.6 ft (2m) S-Video Cable
Cable ZEN 6.6 ft (2m) S-Video Cable
ZENSVID3
Cable ZEN 9.8 ft (3m) S-Video Cable
Cable ZEN 9.8 ft (3m) S-Video Cable
ZENSVID4
Cable ZEN 13.1 ft (4m) S-Video Cable
Cable ZEN 13.1 ft (4m) S-Video Cable
S-Video and Audio over Cat5 Extender
SVIDUTPEXTA
SVIDUTPEXTA
Revised: 05 July 2006 (A)
Certifications (Regulatory etc.) FCC, CE, WEEE, RoHS
Connectors
Input: 1 x RJ45
1 x Stereo Audio RCA
1 x S-Video female
1 x S-Video female
Output: 1 x RJ45
1 x Stereo Audio RCA
1 x S-Video female
1 x S-Video female
Dimensions (LxWxH)
110 x 77 x 24mm
Weight
460g
Maximum Resolution
480i/480p
Bandwidth
DC to 8MHz
Video Source
Cat5 Cable (up to 200m)
Audio Connection
S-Video connection
Support, Warranty Information, and Regulatory Compliance Statement
If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of
online tools, documentation, and downloads. This product is backed by a one-year warranty. In addition,
StarTech.com warrants its products against defects in materials and workmanship for the periods noted, following the
initial date of purchase. During this period, the products may be returned for repair, or replacement with equivalent
products at our discretion. The warranty covers parts and labor costs only. StarTech.com does not warrant its products
from defects or damages arising from misuse, abuse, alteration, or normal wear and tear. Limitation of Liability: In no
event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or
agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of
profits, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual
price paid for the product. Some states do not allow the exclusion or limitation of incidental or consequential dam-
ages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.
FCC Compliance Statement: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
If you ever need help with your product, visit www.startech.com/support and access our comprehensive selection of
online tools, documentation, and downloads. This product is backed by a one-year warranty. In addition,
StarTech.com warrants its products against defects in materials and workmanship for the periods noted, following the
initial date of purchase. During this period, the products may be returned for repair, or replacement with equivalent
products at our discretion. The warranty covers parts and labor costs only. StarTech.com does not warrant its products
from defects or damages arising from misuse, abuse, alteration, or normal wear and tear. Limitation of Liability: In no
event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or
agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of
profits, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual
price paid for the product. Some states do not allow the exclusion or limitation of incidental or consequential dam-
ages. If such laws apply, the limitations or exclusions contained in this statement may not apply to you.
FCC Compliance Statement: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency ener-
gy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Jack Position
Pair 1
Pair 4
Pair 2
Pair 3
1
2
3
4
5
6
7
8
Pin
Color
Function
1
W-O
S-Video
2
O
S-Video
3
W-G
S-Video
4
BL
Audio R
5
W-BL
Audio R
6
G
S-Video
7
W-BR
Audio L
8
BR
Audio L
Pinout definition: