ZyXEL 792H 91-004-342001B User Manual
Product codes
91-004-342001B
Prestige 791R G.SHDSL Router
Remote Node TCP/IP Configuration
24-9
Figure 24-6 Remote Node Filter (RFC1483 or ENET ENCAP Encapsulation)
24.5 Editing ATM Layer Options
Follow these steps to edit Menu 11.6 – Remote Node ATM Layer Options.
Step 1.
In Menu 11.1, move the cursor to the Edit ATM Options then press [SPACE BAR] to toggle
and set the value to Yes.
and set the value to Yes.
Step 2.
Press [ENTER] to open Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of Menu 11.6 for the Prestige, depending on whether you chose VC-based or LLC-
based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.
based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.
24.5.1 VC-based Multiplexing (non-PPP Encapsulation)
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, e.g., VC1
will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.
will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.
Figure 24-7 Menu 11.6 for VC-based Multiplexing (non-PPP Encapsulation)
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
VC Options for IP: VC Options for Bridge:
VPI #= 0 VPI #= N/A
VPI #= 0 VPI #= N/A
VCI #= 38 VCI #= N/A
ATM QoS Type= UBR ATM QoS Type= N/A
Peak Cell Rate (PCR)= 0 Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= 0 Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBS)= 0 Maximum Burst Size (MBS)= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Separate VPI and
VCI numbers must
be specified.