PeakOptical PSFP-03-1311S-12F Data Sheet
Data Sheet
155Mb/s Hot Pluggable, Duplex LC, +3.3V, 1310nm, FP-LD,
Single-Mode SFP Optical Transceiver without DDMI
Single-Mode SFP Optical Transceiver without DDMI
PSFP-03-1311S-12F
Issue: October 2008
All rights reserved, including intellectual property rights. Technical data subject to modifications and delivery subject to availability. Any liability
that the data and illustrations are complete, actual or correct is excluded. Designations may be trademarks and/or copyrights of the respective
that the data and illustrations are complete, actual or correct is excluded. Designations may be trademarks and/or copyrights of the respective
manufacturer, the use of which by third parties for their own purposes may infringe the rights of such owner.
Copyright © PeakOptical Technology A/S 2008-2010. Published at www.peakoptical.com
Copyright © PeakOptical Technology A/S 2008-2010. Published at www.peakoptical.com
Pin Assignment:
Pin out of Connector Block on Host Board
Pin Description:
Notes:
1. Circuit ground is internally isolated from chassis ground.
2. Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V.
3. Should be pulled up with 4.7k – 10kohms on host board to a voltage between 2.0V and 3.6V.
2. Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V.
3. Should be pulled up with 4.7k – 10kohms on host board to a voltage between 2.0V and 3.6V.
MOD_DEF(0) pulls line low to indicate module is plugged in.
4. LOS is open collector output. Should be pulled up with 4.7k – 10k ohms on host board to a voltage
between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of signal.