Intermec 073290-001 User Manual

Insert the new display assembly into the top cover. 

Attach the display flex cable and the keypad flex cable to the main PCB. 

Replace the main PCB and secure it with the two Phillips screws 
removed in Step 3. 

Connect the power indicator/good read light pipe assembly cable and 
the speaker PCB cable to the main PCB. 

Close the CK30. For help, see “Closing the CK30” on page 27. 

To replace the keypad assembly, you need the following tools: 

•  T10 Torx screwdriver 

•  Small Phillips screwdriver 

You also need one of the following parts depending on the CK30 
configuration: 

•  CK30 42-key keypad assembly (P/N 072857-002) 

•  CK30 50-key keypad assembly (P/N 072858-003) 

•  CK30 52-key keypad assembly (P/N 072859-002) 

•  Keypad flex cable (P/N 073094-001) 

•  KA22 x 6 WN 1412 Elco screw (591825-001) 

Remove the bezel assembly. For help, see “Replacing the Bezel 
Assembly” on page 17. 

Pry up one corner of the keypad assembly and carefully lift it away from 
the top cover being careful not to detach or damage the keypad flex 
cable. 

 

 

Keypad
assembly

 

Disconnect the keypad flex cable from the keypad assembly.