Cisco C7200-JC-PA C7200-JC-PA= Data Sheet
Product codes
C7200-JC-PA=
Data Sheet
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 2 of 4
The Cisco 7200VXR Series Port Adapter Jacket Card is supported with the following network
processing engines:
●
Cisco NPE-G1
●
Cisco NPE-G2
Note:
An I/O controller card is required on systems with the Cisco NPE-400 and below.
Therefore, the I/O controller slot is occupied and the port adapter jacket card cannot be inserted
because it comes in I/O slot format.
Supported Port Adapters
The Cisco 7200VXR Series Port Adapter Jacket Card supports the following port adapters:
●
Cisco VPN Acceleration Module 2 (SA-VAM2)-Supported only in combination with NPE-G1
●
AES wide key crypto card (SA-VAM2+)
●
2-Port Packet/SONET OC3c/STM1 Port Adapter (PA-POS-2OC3)
●
2 Port T3 Serial Port Adapter Enhanced (PA-MC-2T3+)
●
1 port multichannel STM-1multi- and single mode port adapter (PA-MC-STM-1MM, PA-MC-
STM-1SMI)
●
1 port ATM port adapters (PA-A3-T3, PA-A3-E3, PA-A3-OC3MM, PA-A3-OC3SMI, PA-A3-
OC3SML, PA-A6-T3, PA-A6-E3, PA-A6-OC3MM, PA-A6-OC3SMI, PA-A6-OC3SML)
Note:
The Cisco Mix-Enabled T1/E1 Port Adapters for the Cisco 7200VXR Series router are not
compatible with the Port Adapter Jacket Card.
Software
The Cisco 7200VXR Series Port Adapter Jacket Card is supported in the following Cisco IOS
®
Software versions at the time of first customer shipment:
●
For NPE-G1
◦
12.4(7)
◦
12.4(6)T1
◦
12.2(28)SB
●
For NPE-G2
◦
12.4(4)XD
◦
12.2(31)SB8
●
For ATM port adapter on both NPE-G1 and NPE-G2
◦
12.4(15)T1
◦
12.2(31)SB8