Intermec 073289-001 User Manual

Once a corner of the bezel is loose, gently pull up on the bezel to 
remove it. 

Remove the adhesive residue left on the top cover from the bezel 
assembly. 

Separate the adhesive strip from the back of your new bezel assembly. 

Insert the keypad bezel end of the assembly, snap it into place, and then 
press down firmly on the overlay surrounding the display to attach the 
bezel assembly to the CK30 top cover. 

To replace the display assembly, you need the following tools: 

•  T10 Torx screwdriver 

•  Small Phillips screwdriver 

• Straight-slot screwdriver 

You also need one or more of the following parts depending on the CK30 
configuration: 

•  Monochrome display assembly (P/N 073237S-001) 

•  Color display assembly (P/N 073238S-001) 

•  Power indicator/good read light pipe assembly (P/N 073030-002) 

•  User indicator light pipe assembly (P/N 073362-001) 

•  Speaker PCB assembly (P/N 073146-002) 

•  KA22 x 6 WN 1412 Elco screw (591825-001) 

 

Open the CK30. For help, see “Opening the CK30” on page 9. 

Disconnect the power/good read indicator light pipe assembly cable 
and the speaker PCB assembly cable from the main PCB. 

Remove the two Phillips screws with captive washers from the top of 
the main PCB and gently separate the main PCB from the top cover 
as shown in the next illustration. 

Detach the display flex cable and the keypad flex cable from the main 
PCB and remove the main PCB.