Philips CD Soundmachine AZ127 AZ127/05 User Manual

2

EN

1 Important

•  Read these instructions.

•  Follow all instructions.

•  Do not block any ventilation openings. 

Install in accordance with the 

manufacturer's instructions.

•  Do not install near any heat sources such 

as radiators, heat registers, stoves, or 

other apparatus (including amplifiers) that

produce heat. 

•  Protect the power cord from being 

walked on or pinched, particularly at plugs, 

convenience receptacles, and the point 

where they exit from the unit.

•  Only use attachments/accessories specified

by the manufacturer.

•  Unplug this unit during lightning storms or 

when unused for long periods of time. 

•  Recording is permissible insofar as 

copyright or other rights of third parties 

are not infringed upon.

•  Refer all servicing to qualified service

personnel. Servicing is required when the 

unit has been damaged in any way, such 

as power-supply cord or plug is damaged, 

liquid has been spilled or objects have 

fallen into the apparatus, the unit has been 

exposed to rain or moisture, does not 

operate normally, or has been dropped.

•  Battery usage CAUTION – To prevent 

battery leakage which may result in bodily 

injury, property damage, or damage to the 

unit: 

•  Install all batteries correctly, + and - as 

marked on the unit. 

•  Do not mix batteries (old and new or 

carbon and alkaline, etc.).

•  Remove batteries when the unit is not 

used for a long time.

•  Batteries (battery pack or batteries 

installed) shall not be exposed to excessive

heat such as sunshine, fire or the like.

•  CAUTION: Danger of explosion if battery 

is incorrectly replaced. Replace only with 

the same or equivalent type.

•  The unit shall not be exposed to dripping 

or splashing. 

•  Do not place any sources of danger on 

the unit (e.g. liquid filled objects, lighted

candles).

•  Where the MAINS plug or an appliance 

coupler is used as the disconnect device, 

the disconnect device shall remain readily 

operable.

Warning

 

•

Never remove the casing of this apparatus. 

 

•

Never place this apparatus on other electrical 

equipment.

 

•

Never look into the laser beam inside this apparatus.

 

Mains fuse

This information applies only to products with a 

UK mains plug.

This product is fitted with an approved molded

plug. If you replace the fuse, use one with:

•  the ratings shown on the plug,

•  a BS 1362 approval, and

•  the ASTA approval mark.

Contact your dealer if you are not sure about 

what type of fuse to use.

Caution: To conform with the EMC directive 

(2004/108/EC), do not detach the plug from

the power cord.

Caution

 

•

Use of controls or adjustments or performance of 

procedures other than herein may result in hazardous 

radiation exposure or other unsafe operation.