Wilson Electronics 304453 User Manual

4 . If there is an “X” next to one of the gain values, this indicates that the 

corresponding frequency has been shut off due to an oscillation .
b . A red light indicates that the frequency has been turned off due to an 

oscillation .

Note: A orange light indicates that the receiver has been turned off. 

R

70A

OVERLOAD

62  AA’ 72

A

75

A

70X

A

75

Band

Select

Reset

800

MHz

1700

/2100

MHz

UP

DOWN

1900

MHz

700

MHz

Band

Select

Reset

800

MHz

1700

/2100

MHz

UP

DOWN

1900

MHz

700

MHz

Power

Selectable

GAIN

GAIN

“X”= Oscillation

 Warning:  The Outside Antenna must always be located so the back 

or side points to the Inside Antenna . Never point the front 

of the Outside Antenna toward the Inside Antenna – this is 

to prevent oscillation .

 Warning:  Connecting the Signal Booster directly to the cell phone with 

use of an adapter will damage the cell phone and/or Signal 

Booster .

 Warning:  Use only the correct Wilson Electronics power supply . Use 

of a non-Wilson Electronics product may damage your 

equipment .

 Warning: 

RF Safety: All inside antennas used with this Signal 

Booster may not have gain (less cable loss) that exceeds 

10 .1 dBi and must be located at least 8 inches from all 

people . Outside fixed antennas may not have gain that 

exceeds 2 .8 dBi (less cable loss) and must be located 

least 27 inches from all people . The outside fixed antenna 

must be connected with a minimum of 26’ of RG58 coaxial 

cable . All antennas shown on page one meet these 

requirements .

 Warning:  Verify that both the Outside Antenna and the Inside 

Antenna are connected to the Signal Booster before 

powering up the Signal Booster .