Wilson Electronics 859994 User Manual

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: tech@wilsonelectronics.com. Mon.- Fri. Hours: 7 am to 6 pm MST.

Installing the Wilson Electronics In-Line

Select a location to install the In-Line that is away from excessive heat, direct

sunlight, moisture and has proper ventilation . Do not place in an air-tight enclosure .

Recommended installation locations for the In-Line are:

• On a shelf
• In a closet
• Near a power outlet
• Near the Inside Antenna
• Where there is more than 5dB loss between

In-Building Signal Booster and Inside Antenna

Note: It is important to have adequate air ventilation. Maintain at least 6 inches of

clearance from surrounding objects.

The In-Line should be placed where it can make up for installation gain loss due to

cable, taps or splitters . Optimal location is near or directly connected to the Inside

Antenna .

Note: For distances of 20 feet or more, use Wilson low loss cable to prevent

significant signal loss or contact Wilson Electronics Technical Support Team

for assistance: 866-294-1660.

Note: Be careful when plugging the connector in so as not to damage the center

pins on the connectors.

IMPORTANT NOTICE

• It is very important to power your Signal Booster using a surge

protected AC Power Strip with at least a

1000 Joule rating.

• Failure to do this will void your warranty in the event of a power surge

or lightning strike .