ZyXEL 202H 91-003-194001B User Manual
Product codes
91-003-194001B
P-202H Plus v2 User’s Guide
Chapter 29 Firmware and Configuration File Maintenance
276
Figure 174 Successful Backup Confirmation Screen
29.3 Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your ZyXEL
Device since FTP is faster. Please note that you must wait for the system to automatically
restart after the file transfer is complete.
Device since FTP is faster. Please note that you must wait for the system to automatically
restart after the file transfer is complete.
Note: WARNING! Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE YOUR ZyXEL Device.
29.3.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter
upload in this chapter
Figure 175 Telnet into Menu 24.6.
1 Launch the FTP client on your computer.
2 Enter “open”, followed by a space and the IP address of your ZyXEL Device.
** Backup Configuration completed. OK.
### Hit any key to continue.###
### Hit any key to continue.###
Menu 24.6 - Restore Configuration
To transfer the firmware and the configuration file, follow the procedure
below:
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-spt is the
remote file name on the router. This restores the configuration to
your router.
4. The system reboots automatically after a successful file transfer.
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type "put backupfilename rom-0" where backupfilename is the name of
your backup configuration file on your workstation and rom-spt is the
remote file name on the router. This restores the configuration to
your router.
4. The system reboots automatically after a successful file transfer.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on restoring using TFTP (note that you must
remain on this menu to restore using TFTP), please see your router
manual.
client program. For details on restoring using TFTP (note that you must
remain on this menu to restore using TFTP), please see your router
manual.
Press ENTER to Exit: