ZyXEL 202H 91-003-194001B User Manual

P-202H Plus v2 User’s Guide

Chapter 2 Introducing the Web Configurator

42

2 Press the RESET button for ten seconds or until the POWER LED begins to blink and 

then release it. When the POWER LED begins to blink, the defaults have been restored 
and the ZyXEL Device restarts.

The following summarizes how to navigate the web configurator from the Site Map screen.

Figure 8    Web Configurator: Main Screen 

Note: Click the 

 icon (located in the top right corner of most screens) to view 

embedded help.

The following table describes the sub-menus. 

Table 2   Web Configurator Screens Summary

Wizard Setup

Use these screens for initial configuration including general 

setup, ISP parameters for Internet Access and WAN IP/DNS 

Server/MAC address assignment.

Advanced Setup

Password

Use this screen to change your password.

LAN

LAN Setup

Use this screen to configure LAN DHCP and TCP/IP settings.

WAN

Internet Access 

Setup

Use this screen to configure Internet Service Provider 

parameters.

NAT

NAT Mode

Use this screen to enable NAT.

SUA Server

Use this screen to configure servers behind the ZyXEL Device.

Address Mapping

Use this screen to configure network address translation 

mapping rules.

Dynamic DNS

Use this screen to allow the ZyXEL Device to use dynamic host 

name resolution.

Firewall

Config

Use this screen to enable the firewall.

Email

Use this screen to send logs and alert messages to an email 

account.

Click Logout any time to exit the 

web configurator.