Siig Dual Monitor Desk Stand - 13" to 24" CE-MT1712-S1 User Manual
Product codes
CE-MT1712-S1
2
Unpacking
•
Carefully remove the contents and lay out on cardboard or other protective surface
•
Check package contents against the parts list to ensure that all components were received
undamaged. Do not use damaged or defective parts
•
Carefully read all instructions before attempting installation
Safety Information
•
Use proper safety equipment during installation
•
If you don't understand the installation instructions, please consult an installation
specialist
•
This mount contains small parts which can act as a choking hazard if swallowed
•
Do not use this product for any purpose or in any configuration not explicitly specified
in these instructions
Tools Required
•
Phillips screwdriver
•
3/8" drill bit (for Grommet installation)
•
Electric drill (for Grommet installation)
Parts List
a - (1x) 48mm
Tube Support
Tube Support
c - (2x) Vesa
Plate
Plate
e - (1x) Arm
Connect Plate
Connect Plate
i - (2x) Arm Plastic
Cover
Cover
j - (3x) M6x29
Bolt
Bolt
k - (1x) Decorative
Cover
Cover
l - (1x) Grommet
Plate
Plate
m - (1x) Grommet
Bolt
Bolt
n - (1x) Wing
Nut
Nut
o - (3x) Allen
Key
Key
p - (16x) M4
Washer
Washer
b - (1x) Weighted
Base
Base
d - (2x) Curved
Arm
Arm
f - (1x) Arm
Clamp
Clamp
g - (4x) M6x25
Bolt
Bolt
h - (4x) M6
Washer
Washer
r - (8x) M4x30
Bolt
Bolt
s - (8x) M4
Spacer
Spacer
t - (2x) M8x10
Bolt
Bolt
u - (2x) Wire
clip
clip
q - (8x) M4x12
Bolt
Bolt