Aruba AP-115 Data Sheet
Aruba 110 Series Access Points
Aruba Data Sheet
Wireless rAdio sPeciFicAtions
•
AP type: Indoor, dual radio, 5-GHz and 2.4-GHz 802.11n 3x3:3
•
Software-configurable dual radio supports 5-GHz (Radio 0) and
2.4-GHz (Radio 1)
2.4-GHz (Radio 1)
•
3x3 MIMO with three spatial streams and up to 450 Mbps
wireless data rate
wireless data rate
•
Supported frequency bands (country-specific restrictions apply):
- 2.4000 to 2.4835 GHz
- 5.150 to 5.250 GHz
- 5.250 to 5.350 GHz
- 5.470 to 5.725 GHz
- 5.725 to 5.850 GHz
•
Available channels: Dependent on configured regulatory domain
•
Dynamic frequency selection (DFS) optimizes the use of
available RF spectrum
available RF spectrum
•
Supported radio technologies:
- 802.11b: Direct-sequence spread-spectrum (DSSS)
- 802.11a/g/n: Orthogonal frequency-division multiplexing (OFDM)
•
Supported modulation types:
- 802.11b: BPSK, QPSK, CCK
- 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM
•
Transmit power: Configurable in increments of 0.5 dBm
•
Maximum (aggregate, conducted total) transmit power (limited
by local regulatory requirements):
by local regulatory requirements):
- 2.4-GHz band: +28 dBm (23 dBm per chain)
- 5-GHz band: +25 dBm (20 dBm per chain)
•
Advanced Cellular Coexistence (ACC) minimizes interference
from LTE cellular networks
from LTE cellular networks
•
Maximum ratio combining (MRC) for improved receiver performance
•
Cyclic delay/shift diversity (CDD/CSD) for improved downlink
RF performance
RF performance
•
Short guard interval for 20-MHz and 40-MHz channels
•
Space-time block coding (STBC) for increased range and
improved reception
improved reception
•
Low-density parity check (LDPC) for high-efficiency error
correction and increased throughput
correction and increased throughput
•
Supported data rates (Mbps):
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: 6.5 to 450 (MCS0 to MCS23)
•
802.11n high-throughput (HT) support: HT 20/40
•
802.11n packet aggregation: A-MPDU, A-MSDU
PoWer
•
Maximum power consumption: 13 watts, plus up to 2.5 watts
for attached USB device.
for attached USB device.
•
Power sources sold separately
•
Direct DC source: 12 Vdc nominal, +/- 5%
•
Power over Ethernet (PoE): 48 Vdc (nominal) 802.3af or
802.3at-compliant source
802.3at-compliant source
- USB host port is disabled when using an 802.3af PoE power
source; for unrestricted operation with PoE power, use an
802.3at compliant source
802.3at compliant source
AntennAs
•
AP-114: Three RP-SMA connectors for external dual-band
antennas. Internal loss between radio interface and external
antenna connectors (due to diplexing circuitry): 1.5 dB in
2.4-GHz and 2.5 dB in 5-GHz.
antennas. Internal loss between radio interface and external
antenna connectors (due to diplexing circuitry): 1.5 dB in
2.4-GHz and 2.5 dB in 5-GHz.
•
AP-115: Six integrated down-tilt omni-directional antennas for
3x3 MIMO with maximum antenna gain of 4.5 dBi in 2.4-GHz
and 5.5 dBi in 5-GHz. Built-in antennas are optimized for
horizontal ceiling mounted orientation of AP-115.
3x3 MIMO with maximum antenna gain of 4.5 dBi in 2.4-GHz
and 5.5 dBi in 5-GHz. Built-in antennas are optimized for
horizontal ceiling mounted orientation of AP-115.
otHer interFAces
•
10/100/1000BASE-T Ethernet network interface (RJ-45)
- Auto-sensing link speed and MDI/MDX
- 802.3az Energy Efficient Ethernet (EEE)
- PoE-PD: 48 Vdc 802.3af PoE or 802.3at PoE+
•
DC power interface, accepts 1.7/4.0-mm center-positive
circular plug with 9.5-mm length
circular plug with 9.5-mm length
•
USB 2.0 host interface (Type A connector)
•
Serial console interface (RJ-45, TTL levels)
•
Visual indicators (LEDs):
- Power/system status
- Ethernet link status (ENET)
- Radio status (2x; RAD0, RAD1)
•
Kensington security slot
•
Reset button
MountinG
•
Included with AP:
- Mounting brackets (2) for attaching to 9/16-inch or
15/16-inch T-bar drop-tile ceiling
•
Optional mounting kits:
- AP-220-MNT-C2: Aruba AP mount kit contains two ceiling-
grid rail adapters for Interlude and Silhouette style rails
- AP-220-MNT-W1: Aruba AP mount kit contains one flat-
surface wall/ceiling mount bracket
- AP-220-MNT-W2: Aruba AP mount kit contains one flat-
surface wall/ceiling secure mount cradle
MecHAnicAl
•
Dimensions/weight (unit, excluding mount accessories):
- 180 mm (W) x 180 mm (D) x 45 mm (H)
- 7.09” (W) x 7.09” (D) x 1.77” (H)
- 650 g (1.43 lbs)
•
Dimensions/weight (shipping):
- 220 mm (W) x 225 mm (D) x 55 mm (H)
- 8.66” (W) x 8.86” (D) x 2.17” (H)
- 880 g (1.94 lbs)
environMentAl
•
Operating:
- Temperature: 0° C to +50° C (+32° F to +122° F)
- Humidity: 5% to 95% non-condensing
•
Storage and transportation temperature range:
- Temperature: -40° C to +70° C (-40° F to +158° F)