Philips Smart All-in-One S221C3ANW S221C3ANW/00 User Manual
Product codes
S221C3ANW/00
2
1. For your safety
• The SMART All-in-One is equipped with
a three-pronged grounded plug, a plug
with a third (grounding) pin. This plug will
fit only into a grounded power outlet as
a safety feature. If your outlet does not
accommodate the three-wire plug, have an
electrician install the correct outlet, or use
an adapter to ground the appliance safely.
Do not defeat the safety purpose of the
grounded plug.
• Unplug the unit during a lightening storm
or when it will not be used for long period
of time. This will protect the SMART All-in-
One from damage due to power surges.
• Do not overload power strips and
extension cords. Overloading can result in
fire or electric shock.
• Never push any object into the slot on the
SMART All-in-One cabinet. It could short
circuit parts causing a fire or electric shock.
Never spill liquids on the SMART All-in-
One.
• Do not attempt to service the SMART All-
in-One by yourself; opening or removing
covers can expose you to dangerous
voltages and other hazards. Please refer all
servicing to qualified service personnel.
• To ensure satisfactory operation, use
the SMART All-in-One only with UL
listed computers which have appropriate
configured receptacles marked between
100 - 240V AC, Min. 5A.
• The wall socket shall be installed near the
equipment and shall be easily accessible.
• For use only with the attached power
adapter (Output 19V DC) which have UL,
CSA listed licensed (only for monitor with
power adapter).
Model: ADPC1965
Model: ADPC1965
Manufacturer: TPV ELECTRONICS
(FUJIAN) CO., LTD.
Model:
ADS-65LSI-19-1 19065G
Manufacturer: SHENZHZEN HONOR
ELECTRONIC CO., LTD.
1.2 Cleaning
• Clean the cabinet regularly with cloth. You
can use soft-detergent to wipe out the
stain, instead of strong-detergent which will
cauterize the product cabinet.
• When cleaning, make sure no detergent is
leaked into the product. The cleaning cloth
should not be too rough as it will scratch
the screen surface.
• Please disconnect the power cord before
cleaning the product.
1.3 Special notes on SMART All-in-
One
The following symptoms are normal with
SMART All-in-One and do not indicate a
problem.
Note
• Due to the nature of the fluorescent light,
the screen may flicker during initial use. Turn
off the Power Switch and then turn it on
again to make sure the flicker disappears.
• You may find slightly uneven brightness
on the screen depending on the desktop
pattern you use.
• The LCD screen has effective pixels of
99.99% or more. It may include blemishes
of 0.01% or less such as a missing pixel or a
pixel lit all of the time.
• Due to the nature of the LCD screen, an
afterimage of the previous screen may
remain after switching the image when the
same image has been displayed for a long
time. The SMART All-in-One will slowly
recover from this.
• When the screen becomes black or
flashing, or cannot illuminate any more,
contact your dealer or service center to
replace parts. Don’t repair the screen by
yourself!