Havis C-VS-1800-CAPR-1 User Manual
C-VS-1800-CAPR-1_INST_1-12
Place console assembly into position
and attach to brackets with 1/4"x 3/4"
hex bolts and flat washers.
(Three per side)
Wire harnesses can be routed through
lower dash as shown.
End of extrusion should line up with
the end of bracket.
(Passenger side shown)
Tighten all mount hardware
Adjust brackets if needed.
Run wire harnesses as needed.
Attach extrusion to brackets with 1/4"
x 1/2” hex bolts and flat washers.
(Driver side shown)
Extrusion platform is now in place.
Push down and tighten hardware.
Assemble console housing and
accessory box with 1/4” x 1/2”
accessory box with 1/4” x 1/2”
carriage bolts and serrated nuts.