Philips HDR5710 HDR5710/F7 User Manual

EN

After you have completed All of the Connections to your TV, 
review the Steps below.

Press [  (Power-ON) ] to Turn On the 

unit.

Turn On your TV.

Find the Button on the TV’s Remote 

Control that accesses the External Source 

Input. (The button may be labeled ‘Source’, 

‘Select’ or ‘Input’. Refer to your TV’s user 

manual.)

Press that Button Repeatedly until you see 

the Welcome Screen on the TV screen. 

•  If you see the Welcome Screen, that is the correct 

viewing Source Input associated with this unit’s output. 
Make sure to always select this Source Input on your 
TV when using this unit.

•  If the TV is connected using an HDMI cable, it may 

take a few moments until the Welcome Screen 
appears.

Please follow the instructions below to complete the Initial Setup.

While the Welcome Screen is displayed, 

press [ OK ].

•  ‘Language Setting’ screen will appear.
•  In Initial Setup, pressing [ BACK ] lets you go back to 

the previous screen. Also, pressing [   /   ]  lets you 
go back to the previous screen or go forward to the 
next screen when it is available.

Select your Language using [   /   ], then 

press [ OK ].

Select your menu 
language with the 
Up/Down buttons 
on your remote 
control, press the 
OK button to 
proceed.

 English

 Français

 Español

•   ‘Country Setting’ screen will appear.

Select your Country using [   /   ], then 

press [ OK ].

•  ‘Antenna / Cable Signal Setting’ screen will appear.

Select “Antenna” or “Cable” using [   /   ], 

then press [ OK ].

•  Select “Antenna” for Terrestrial Broadcasting. 

Select “Cable” for Cable Television. Then, Channel Scan 
will begin.

•  Select “Skip” if you wish to Skip this Setting.

System searching. Please wait...

Digital Channels found:

0

Analog Channels found:

0

Auto Channel Programming may take more than 20 Minutes to 
complete. Digital will take longer than Analog Channels to find 
and program the Channels. Please wait until you see the Auto 
Programming Complete Message.

Stop

•  If you wish to Skip Scanning, select “Stop” by pressing 

[ OK ].

Press [ OK ] on Finish.

•  ‘Time Zone’ screen will appear.

EEC30UH_Philips_SmartDVR_v1_EN.indb   21

EEC30UH_Philips_SmartDVR_v1_EN.indb   21

2013/09/13   15:38:15

2013/09/13   15:38:15