Havis C-TCB-24 Leaflet
C-TCB-24_INST_6-09
Always!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
INSTALLATION:
•
Remove front passenger seat bolts. Loosen but do not remove rear bolts.
Note: When installing C-TCB-24 into Extended Cab or Crew Cab pick-ups, the air duct on the
passenger side floor must be cut out or completely removed to install.
passenger side floor must be cut out or completely removed to install.
•
Slide base of the pole support assembly under the seat base brackets.
•
Align the holes of the seat base, the pole support assembly and floor holes. Replace
front seat bolts. Firmly tighten all seat bolts without over tightening.
front seat bolts. Firmly tighten all seat bolts without over tightening.
•
Attach lateral brace arm assembly to the pole support assembly with 5/16” x 1” Hex
head bolt, washer and nylock nut.
head bolt, washer and nylock nut.
•
Secure lateral brace arm to side of the transmission hump using ¼” x ¾” Hex head
lag bolts.
lag bolts.
Note: When mounting side support brace to floor of vehicle, be sure to check for obstructions prior to
drilling or lag bolting to floor.
•
Tighten the screw that attaches the brace arm to the pole support assembly last.
•
Tighten down factory passenger seat bolts and 5/16-18-nylock nut holding side
support brace to pole support assembly.
support brace to pole support assembly.
•
Mount optional C-3090, computer-mounting platform, to passenger-side mount
assembly using hardware and instructions provided with C-3090.
assembly using hardware and instructions provided with C-3090.