Philips CD Soundmachine AZ102C AZ102C/79 User Manual

1  Check if the power voltage, as shown on

the type plate located on the bottom
of the set, corresponds to your local power
supply. If it does not, consult your dealer or
service center.

2  Connect the power cord to the AC

MAINS~ inlet and the wall socket.The set is
now connected and ready for use.

3  To switch the set off completely, withdraw the

power cord from the wall socket.

Install the unit near the AC outlet and where
the AC power plug can be easily reached.

A

Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.

–

1  To select your sound source, adjust the

Source selector to: CD, FM or MW.

To switch off the set, adjust the Source 
selector to STANDBY position.

To switch to LINE IN mode, connect an
external audio source to the LINE-IN inlet.

A

The set switches to LINE IN mode
automatically when an external audio source
is connected, no matter the set is in CD, FM
or MW mode.

A

The LINE-IN inlet is not for earphones.

Adjust the sound with the VOLUME and
DBB controls.

1  Adjust the Source selector to FM or

MW.

2  Turn TUNING to tune to a station.

A

For FM, extend, incline and turn the
telescopic antenna for best reception. Reduce
its length if the signal is too strong.

A

For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.