Intel 3560M CW8064701486906 Data Sheet

Datasheet

103

Intel is working with two logic analyzer vendors to provide logic analyzer interfaces 

(LAIs) for use in debugging systems. Tektronix and Agilent should be contacted to get 

specific information about their logic analyzer interfaces. The following information is 

general in nature. Specific information must be obtained from the logic analyzer 

vendor. 

Due to the complexity of systems, the LAI is critical in providing the ability to probe and 

capture FSB signals. There are two sets of considerations to keep in mind when 

designing a system that can make use of an LAI: mechanical and electrical.

The LAI is installed between the processor socket and the processor. The LAI lands plug 

into the processor socket, while the processor lands plug into a socket on the LAI. 

Cabling that is part of the LAI egresses the system to allow an electrical connection 

between the processor and a logic analyzer. The maximum volume occupied by the LAI, 

known as the keepout volume, as well as the cable egress restrictions, should be 

obtained from the logic analyzer vendor. System designers must make sure that the 

keepout volume remains unobstructed inside the system. Note that it is possible that 

the keepout volume reserved for the LAI may differ from the space normally occupied 

by the processor’s heatsink. If this is the case, the logic analyzer vendor will provide a 

cooling solution as part of the LAI.

The LAI will also affect the electrical performance of the FSB; therefore, it is critical to 

obtain electrical load models from each of the logic analyzers to be able to run system 

level simulations to prove that their tool will work in the system. Contact the logic 

analyzer vendor for electrical specifications and load models for the LAI solution it 

provides.