Uniwide UniServer 1522VA 008-00134A Manual

Product codes
008-00134A
Page of 102
 
21
 
3.2.2  Memory 
The system mainboard uses Dual Inline Memory Modules (DIMM). Two pair's banks are available;   
each bank supports one CPU with Hyper Transport Technology. The memory DIMMs accommodates Registered 
ECC (400/533/667) SDRAM DIMM and Double Data Rate Memory (DDR2) memory modules in 128MB, 
256MB, 512MB, 1GB, and 2GB, 4GB combinations. Total memory size for one CPU is up to 32GB. 
 
 
CAUTION 
The system mainboard has strict memory type and timing requirements.   
Before you purchase DDR (Double Data Rate) memory for using in the system mainboard, you should 
contact your local reseller for a recommend list of system memory that has been validated on this 
system. It only supports registered memory, not supports unbuffered type memory. 
CAUTION 
To take advantage of the 128-bit interface, you must install DIMMs in pairs of two. DIMM0 and DIMM1 
are paired; DIMM2 and DIMM3 are paired; DIMM4 and DIMM5 are paired; and slots DIMM6 and DIMM7 
are paired. If you are only installing two DIMMs into a Memory Bank, it is recommended that you install 
them in slots DIMM6 and DIMM7 to get the full bandwidth. 
NOTE  
For optimal dual-channel DDR operation, installing DIMMs in pair is highly recommended. For two DIMMs 
per CPU, install them far from the CPU. For four or more DIMMs per CPU, install them same method to 
the CPU.   
 
Memory Configuration Chart 
(Note: X indicates a populated DIMM Slot, The chart below does not included all the configuration) 
CPU 0 
CPU 1 
 
DI
MM0 
DI
MM1 
DI
MM2 
DI
MM3 
DI
MM4 
DI
MM5 
DI
MM6 
DI
MM7 
DI
MM0 
DI
MM1 
DI
MM2 
DI
MM3 
DI
MM4 
DI
MM5 
DI
MM6 
DI
MM7 
 
 
 
 
 
 
x
x
 
 
 
 
 
 
 
 
 
 
 
 
x
x
x
x
 
 
 
 
 
 
 
 
  x x x
x
x
x
        
x x x x x
x
x
x
        
 
 
 
 
 
 
x
x
 
 
 
 
 
 
    x
x
x
x
    x x x x 
    x x x
x
x
x
    x
x
x x x x 
128bit m
emory
 s
u
pport 
x x x x x
x
x
x
x
x
x
x
x x x x