Uniwide UniServer 1522VA 008-00134A Manual

Product codes
008-00134A
Page of 102
 
55
 
4.2.6    Cable Connection on the SAS BP 
Connector J4, J5 are used to connect SAS cable to each SAS HDD. 
Connector J8 is used to connect SAS Controller and Enclosure monitoring chip. 
 
 
 
 
 
4.2.7 Jumper Setting on the SAS BP 
Jumper J10, J11 are used to decide which enclosure monitoring controller will use in system. 
Default setting is “1-2” for J10 and “1-3, 2-4” for J11 on-board SATA controller. If you want to use add-on another 
SATA controller supporting SES(I2C) interface, you have to set the jumper to “2-3” for J10 and “3-5, 4-6” for J11. 
 
 
 
       
 
 
 
 
 
 
                                           
4.2.8    Jumper Setting on the SATA BP 
Jumper is used to decide which controller we will use in system. 
Default setting is "ON" for on-board SATA controller. If you want to use add-on SATA controller, you also have to 
set the switch to "ON" like below picture. 
 
Connector
Description 
J4 SAS 
Port 
J5 SAS 
Port 
J8 
Enclosure monitoring connection 
Jumper SGPIO SES(I2C) 
J10 1-2  2-3 
1-3 3-5 
J11 
2-4 4-6 
Default Setting is "ON"