Hitachi RAF-35RPA RAF35RPA User Manual
Product codes
RAF35RPA
10-32
•
Decide the fixing location of remote
controller so that the length of wire shall
be within 15 meters.
controller so that the length of wire shall
be within 15 meters.
CAUTION
•
Do not cut the provided wire. Excess wire should be
properly wound and fitted at safe place
properly wound and fitted at safe place
•
Do not join the wire with additional wire.
•
When connecting the wires via the wall’s recessed
slot:
slot:
1. Fix the bottom casing to the wall by the provided screw
2. Assemble the top casing to the fixed bottom casing.
2. Assemble the top casing to the fixed bottom casing.
(Refer to the illustration below for detail installation
•
When the wires to be connected from inside top
portion of top casing;
portion of top casing;
1. Break off a perforated aperture located at the top
portion of the bottom casing by nipper. Remove sharp
edges around the aperture by cutter.
edges around the aperture by cutter.
2. Fix the bottom casing to the wall by the screw
provided.
3. Connect the wires to the lead wires connector.
4. Mount the wires through the provided slot on top
4. Mount the wires through the provided slot on top
casing.
5. Assemble the top casing to the fixed bottom casing.
(Refer to the illustration below for detail installation)
3. Installation of wireless remote controller
(optional))
•
The remote controller can be placed in its holder
which is fixed on wall or beam
which is fixed on wall or beam
•
To operate the remote controller at its holder,
please ensure that the unit can receive signal
transmitted from the controller at the place where
the holder is to be fixed. The unit will beep when
signal is received from the remote controller. The
signal transmission is weakening by fluorescent
light. Therefore, during the installation of the remote
control holder, please switch on the light, even
during day time, to determine the mounting location
of the holder.
please ensure that the unit can receive signal
transmitted from the controller at the place where
the holder is to be fixed. The unit will beep when
signal is received from the remote controller. The
signal transmission is weakening by fluorescent
light. Therefore, during the installation of the remote
control holder, please switch on the light, even
during day time, to determine the mounting location
of the holder.
Installation of display panel (Optional)
•
Select an installation position on ceiling or wall
where there is no obstacle to interrupt signal
reception.
where there is no obstacle to interrupt signal
reception.
•
Loosen screws of panel installation plate so that
bracket can be slightly moved.
bracket can be slightly moved.
•
Match brackets to the opening on ceiling or wall and
tighten screws until bracket is firmly secured to
ceiling material.
tighten screws until bracket is firmly secured to
ceiling material.
•
Install the panel cover so inside claws are securely
hooked to the panel installation plate
hooked to the panel installation plate
•
Conduct the indoor unit side housing of display
panel cord to the electric box of the indoor unit an
connect it with the housing at the side of the unit.
panel cord to the electric box of the indoor unit an
connect it with the housing at the side of the unit.
⑦
Remote
controller
Top casing
Bottom casing
Lead wires (3 strands
are inserted through
and fastened via rib-
clip
⑧
Wall
mounting
screws
(2 pieces)
Location of
wall
mounting
screw
Lead wires
connector
Wires
Wires
Lead
wires
connector
Wires
Wi
res
Lead wires
(3 strands)
Lead wires
connector
0.50 gap
W
al
l m
o
u
n
ti
n
g
scr
ew
s (
2 p
iece
s
to be
a
u
sed
)