Kingston Technology 32GB DDR3 1866MHz ECC 1.5v KVR18L13Q4/32 User Manual

*Power will vary depending on the SDRAM and 
 Register/PLL used.

Continued >>

ValueRAM’s KVR18L13Q4/32 4G x 72-bit (32GB) DDR3-1866 

CL13 SDRAM (Synchronous DRAM), 4Rx4, load reduced, ECC 

memory module, based on thirty-six DDP 2G x 4-bit 

components. The SPD is programmed to JEDEC standard 

latency DDR3-1866 timing of 13-13-13 at 1.5V. This 240-pin 

LRDIMM uses gold contact fingers. The electrical and 

mechanical specifications are as follows:

• JEDEC  standard 1.5V (1.425V ~ 1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 933MHz fCK for 1866Mb/sec/pin

• 8 independent internal banks

• Programmable CAS latency: 13, 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (interleave without any limit, sequential with
  starting address “000” only), 4 with tCCD = 4 which does not
  allow seamless read or write (either on the fly using A12 or
  MRS)

• Bi-directional Differential Data Strobe

• Internal (self) calibration: Internal self calibration through ZQ
  pin (RZQ: 240 ohm 

± 1%)

• On Die Termination using ODT pin

• On-DIMM thermal sensor (Grade B)

• Average Refresh Period 7.8us at lower than TCASE 85°C,

  3.9us at 85°C < TCASE < 95°Cº

• Asynchronous Reset

• PCB: Height 1.195” (30.35mm), double sided component

 

CL(IDD)

Row Cycle Time (tRCmin)

Refresh to Active/Refresh
Command Time (tRFCmin)

Row Active Time (tRASmin)

Maximum Operating Power

UL Rating

Operating Temperature

Storage Temperature

13 cycles

47.91ns(min.)

260ns(min.)

34ns(min.)

11.070 W*

94 V - 0

0

o

 C to +85

o

 C

-55

o

 C to +100

o

 C

Memory Module Specifi cations

32GB 4Rx4 4G x 72-Bit PC3-14900
CL13 Load Reduced DIMM

Memory Module Specifi cations