RAM Mount RAP-274-1-AP5U Leaflet

RAP-274-1U Instructions

EZ On EZ Off Mount

PART INDEX
(QTY. 1) QUICK RELEASE SPRING LOADED TOP (A)
(QTY. 1) QUICK RELEASE BOTTOM (B)
(QTY. 1) EZ MOUNT RUBBER BASE (C)
(QTY. 1) EZ MOUNT TAPERED RUBBER BASE (D)
(QTY. 2) 7” LONG CABLE TIE (E)
(QTY. 1) 2” x 3” NEOPRENE ADHESIVE STRIP (F)

STEP 1,
Combine quick release bottom (B) with either EZ rubber 
base (C) or (D). Use EZ rubber base (C) for standard 
handlebars, and EZ rubber base (D) for tapered 
handlebars.  Wrap Neoprene strip around bar at location 
Where EZ mount will be installed.  The strip can be 
trimmed as desired but must contact EZ mount at rubber 
base and at the cable ties to prevent slipping.

STEP 2.
Insert zip ties (E) into quick release bottom (B) with 
perforated side facing down towards handlebars. Do not 
fully tighten zip ties until you have reached a desired 
position on handlebars. Once desired position is 
reached, completely tighten and remove excess cable  
tie with scissors.

STEP 3.
Attached quick release spring loaded top (A) to cradle.

STEP 4
Attach assembly from step 3 by pressing it against the 
assembly mounted on handlebar, turning, and then 
letting go.

B

D

A

C

E

F