KanexPro HD50FTCL314 Leaflet

ABOUT KANEXPRO

KanexPro carries a broad selection of A/V connectivity products by leveraging the core strength in professional systems enabling you to broadcast, convert, extend, split, or 
multiply HD signal transmissions; simply and cost-effectively. KanexPro is a trademark. HDMI, the HDMI logo, and High-Definition Multimedia Interface are trademarks or registered 
trademarks of HDMI Licensing, LLC in the United States and/or other countries. All other product or service names are the property of their respective owners.

1405 Pioneer St., Brea, CA 92821
888.975.1368  info@kanexpro.com

• High Speed HDMI cables with Ethernet
• CL3 Rated for In-Wall Installation
• Built-in booster for active signal amplification& 

equalization

• 8–levels of selectable equalization
• Supports 3D and 4Kx2K

Standards: High speed HDMI cable with Ethernet
Data rates: Up to 10.2 Gbps
Color Depth Support: 30 bit, 36 bit and 48 bits 
(16 bits per color)
Vertical Frequency: Supports 60Hz & 120Hz DC-
coupled inputs and outputs
Regulatory Compliance: RoHs compliant and 
CL3 rated
Temperature: -40°C to +85°C operating range
Shielding & Protection:
    Triple-layer shielding for EMI/RFI rejection
    24 AWG copper wire construction

Dimensions:
    HDMI Cable Diameter: 0.37” (9.5mm)
    HDMI Connector: 0.55” H x 0.8”W x 1.5”L
    Built-in Signal Repeater: 0.6”H x 1.00”W x 3.1”L
Net Weight:  3.5 lbs
Warranty: Full 1-Year parts and labor

*NOTICE*
Side labeled “Input” should be connected to the 
source. Side labeled “Output” should be connected to 
the sink (display).

The KanexPro High Speed 
HDMI cables with Ethernet are 
designed with built-in booster 

for applications that require 

high-performance transmission 

of HDMI digital video and multi-

channel audio signals. These 

cables have active amplification 

built-in to prevent impedance 

mismatch, caused by the cable 

attenuation, dielectric losses and 

compensation for skin effect over 

long distances.

For flawless transmission, the 

output of the cable is placed at 

the end of the display to amplify 

full signal transmission with zero 

signal loss. The built-in booster 

does not require an external 

power, since it is using the 5-volt 

from pin-18 on the HDMI cable 

extracting the power from the 

display. These cables are fully 

CL3 certified which surpasses 

any in-wall code requirement 

for residential or commercial 

installations.

High-resolution HDMI cables 
with built-in signal booster
50ft, 75ft, 100ft

High Speed HDMI cables with Ethernet plus 
signal equalization

• Data rates up to 10.2 Gbps
• Support color depths to 48 bits
• HDCP compliant
• Available in lengths of 25 feet, 50 feet, 75 feet 

and 100 feet

• 24 AWG Copper Wire Construction