Alcatel-Lucent OAW-AP175AC User Manual
RF Management
• Spectrum analysis remotely scans the 2.4-GHz and 5-GHz
radio bands to identify sources of RF interference. This provides
visibility into non-802.11 RF interference sources and their effect
on 802.11n channel quality.
radio bands to identify sources of RF interference. This provides
visibility into non-802.11 RF interference sources and their effect
on 802.11n channel quality.
Security
• With an OpenDNS service subscription, Alcatel-Lucent Instant delivers
integrated web filtering, malware and botnet protection to every
device connected to the WLAN
device connected to the WLAN
• Integrated Trusted Platform Module (TPM) for secure storage
of credentials and keys
• SecureJack-capable for secure tunneling of wired Ethernet traffic
Operating Modes
• 802.11a/b/g/n Alcatel-Lucent Instant AP
• 802.11a/b/g/n Mobility Controller-managed AP
• Air monitor (AM)
• Secure enterprise mesh
• Remote AP (RAP) when used with a Mobility Controller
• Spectrum analyzer when used with a Mobility Controller
• 802.11a/b/g/n Mobility Controller-managed AP
• Air monitor (AM)
• Secure enterprise mesh
• Remote AP (RAP) when used with a Mobility Controller
• Spectrum analyzer when used with a Mobility Controller
Wireless Radio Specifications
• AP type: Dual-radio, dual-band 802.11n indoor
• Software-configurable dual radio supports 2.4 GHz and 5 GHz
• 2x2 MIMO 802.11n with two spatial streams and up to
• Software-configurable dual radio supports 2.4 GHz and 5 GHz
• 2x2 MIMO 802.11n with two spatial streams and up to
300 Mbps per radio
• Supported frequency bands (country-specific restrictions apply):
-
-
2.400 to 2.4835 GHz
- 5.150 to 5.250 GHz
- 5.250 to 5.350 GHz
- 5.470 to 5.725 GHz
- 5.725 to 5.850 GHz
- 5.250 to 5.350 GHz
- 5.470 to 5.725 GHz
- 5.725 to 5.850 GHz
• Available channels: Managed by Virtual Controller or Mobility
Controller, dependent upon configured regulatory domain
• Controller-managed, dependent upon configured regulatory domain
• Dynamic frequency selection (DFS) optimizes the use of
• Dynamic frequency selection (DFS) optimizes the use of
available RF spectrum
• Supported radio technologies:
- 802.11b: Direct-sequence spread-spectrum (DSSS)
- 802.11a/g/n: Orthogonal frequency division multiplexing (OFDM)
- 802.11n: 2x2 MIMO with two spatial streams
- 802.11a/g/n: Orthogonal frequency division multiplexing (OFDM)
- 802.11n: 2x2 MIMO with two spatial streams
• Supported modulation types:
-
-
802.11b: BPSK, QPSK, CCK
- 802.11a/g/n: BPSK, QPSK, 16-QAM, 64-QAM
• Transmit power: Configurable in increments of 0.5 dBm
• Maximum transmit power:
-
• Transmit power: Configurable in increments of 0.5 dBm
• Maximum transmit power:
-
2.4GHz: 23 dBm (limited by local regulatory requirements)
- 5 GHz: 23 dBm (limited by local regulatory requirements)
• Maximum ratio combining (MRC) for improved receiver
performance
• Cyclic Delay Diversity for improved downlink RF performance
• Space time blocking code (STBC) for increased range and
• Maximum ratio combining (MRC) for improved receiver
performance
• Cyclic Delay Diversity for improved downlink RF performance
• Space time blocking code (STBC) for increased range and
improved reception
• Association rates (Mbps):
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: MCS0 - MCS15 (6.5 Mbps - 300 Mbps)
• 802.11n high-throughput (HT) Support: HT 20/40
• 802.11n packet aggregation: A-MPDU, A-MSDU
- 802.11b: 1, 2, 5.5, 11
- 802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
- 802.11n: MCS0 - MCS15 (6.5 Mbps - 300 Mbps)
• 802.11n high-throughput (HT) Support: HT 20/40
• 802.11n packet aggregation: A-MPDU, A-MSDU
Power In
• IAP175P and AP175P: 48-volt DC 802.3at power over
Ethernet (PoE+)
• IAP175AC and AP175AC: 100-240-volt AC from external
AC power source
• AP-175DC: 12-48 volt DC from external DC power source
Ethernet (PoE+)
• IAP175AC and AP175AC: 100-240-volt AC from external
AC power source
• AP-175DC: 12-48 volt DC from external DC power source
• Maximum power consumption: 18 watts; excludes power
consumed by any PoE device connected to and powered by the
IAP175AC and AP175AC
consumed by any PoE device connected to and powered by the
IAP175AC and AP175AC
Power Out
• The AC and DC powered models provide an 802.3af PoE power
source (PSE) on the Ethernet interface
source (PSE) on the Ethernet interface
Antenna
• Four N-type female interfaces (two 2.4 GHz and two 5 GHz) for
external MIMO antennas
• Feeder cable may be used for external antenna deployments
external MIMO antennas
• Feeder cable may be used for external antenna deployments
Interfaces
• Network: One 10/100/1000BASE-T Ethernet (RJ-45),auto-sensing link
speed and MDI/MDX
• Power: One AC power connector (IAP-175AC and AP-175AC)
and one DC power connector (IAP-175DC and AP-175DC)
• Other: One USB console interface
and one DC power connector (IAP-175DC and AP-175DC)
• Other: One USB console interface
Mounting
• Wall or mast mounted using the mounting bracket supplied with
the unit; solar shield included
the unit; solar shield included
Mechanical
• Dimensions/weight (unit):
- 225 mm x 225 mm x 105 mm (8.9” x 8.9” x 4.1“), excluding
- 225 mm x 225 mm x 105 mm (8.9” x 8.9” x 4.1“), excluding
connectors
- 3.5 kg (7.7 lb): IAP175P and AP175P
- 4.25 kg (9.4 lb): IAP-175AC, AP175AC and AP175DC
• Dimensions/weight (shipping):
- 395 mm x 348 mm x 375 mm (15.6” x 13.7” x 14.8“)
- 8.25 kg (18.2 lb): IAP175P and AP175P
- 9 kg (19.8 lb): IAP175AC, AP175AC and AP175DC
- 4.25 kg (9.4 lb): IAP-175AC, AP175AC and AP175DC
• Dimensions/weight (shipping):
- 395 mm x 348 mm x 375 mm (15.6” x 13.7” x 14.8“)
- 8.25 kg (18.2 lb): IAP175P and AP175P
- 9 kg (19.8 lb): IAP175AC, AP175AC and AP175DC
Environmental
• Operating Temprature:
- -30° C to 60° C (-22° F to 140° F): IAP175P and AP175P
- -40° C to 55° C (-40° F to 131° F): IAP175A C, AP175AC
and AP175DC
• Operating humidity: 5% to 95% non-condensing
• Operating altitude: Up to 3,000 meters (9,850 feet)
• Storage and transportation temperature range:
- Temperature: -40° C to +70° C (-40° F to +15 8° F)
• Weather rating: IP66
- -30° C to 60° C (-22° F to 140° F): IAP175P and AP175P
- -40° C to 55° C (-40° F to 131° F): IAP175A C, AP175AC
and AP175DC
• Operating humidity: 5% to 95% non-condensing
• Operating altitude: Up to 3,000 meters (9,850 feet)
• Storage and transportation temperature range:
- Temperature: -40° C to +70° C (-40° F to +15 8° F)
• Weather rating: IP66
• Wind survivability: Up to 165 mph
• Shock and vibration: ETSI 300-19-2-4 spec T41.E class 4M3
• Shock and vibration: ETSI 300-19-2-4 spec T41.E class 4M3
Regulatory
• FCC/Industry of Canada
• CE Marked
• R&TTE Directive 1995/5/EC
• Low Voltage Directive 72/23/EEC
• EN 300 328
• EN 301 489
• EN 301 893
• UL/IEC/EN 60950
• CE Marked
• R&TTE Directive 1995/5/EC
• Low Voltage Directive 72/23/EEC
• EN 300 328
• EN 301 489
• EN 301 893
• UL/IEC/EN 60950
Certifications
• CB Scheme Safety, cTUVus
• Wi-Fi certified 802.11a/b/g/n
• Wi-Fi certified 802.11a/b/g/n
Warranty
• One year parts and labor
Minimum AOS version
• 5.0.2.1 on an Alcatel-Lucent Mobility Controller
Alcatel-Lucent OmniAccess 175 Series Access Points
ALCATEL-LUCENT
DATASHEET
2