MIPRO AT-70W AT 70W Leaflet
Product codes
AT 70W
!
When using the RX connector , please be aware that the inside wire of antenna
cable can not touch the case itself to avoid the short circuit. This is due to the
connection socket equipping with the 8V DC power.
!
RX connector socket is only for the receiver and hence it can not apply to the
transmitter. If doing so, it may cause the damage to the transmitter.
!
The shorter length of coaxial cable is the better when it comes to connect the TX/RX
socket to the receiver. It is recommended to remain the cable length within 20m
to avoid the reception signal decrease too much. However the coaxial cable length
has to keep over 20m when using the RX connector , or the signal saturation
would occur due to the over-gain from booster then lead to the anti-interference
deterioration. Hence it will improve the sensitivity by using RX connector , but
meanwhile it requires being aware the anti-interference feature may deteriorate.
AT-70W is a professional wideband transmitting & receiving omni-directional antenna.
Optimized for 470MHz~1GHz in 2~4dBi high directional effect design for environments
that radiates or receives equally well in all directions. The most unique feature of
AT-70W is that it can be connected to either transmitter or receiver for usage. Built-in
12dB high gain booster is designed specifically to increase the signal strength as well as
the longer distance coverage and compensates for coaxial cable signal loss. The
amplifier power derives from the coaxial cables connected to MIPRO AD-707 or AD-707a
antenna divider or ACT-Series receivers. AT-70W is ideal for both indoor and outdoor
applications.
!
TX/RX antenna cable connector can be connected with 20m antenna cable to
MI-808T transmitters, AD-808 antenna combiner. This connector can also be
connected to ACT-Series receivers or AD-707 or AD-707a antenna dividers.
!
RX connector has to adopt the antenna cable which the length is over 20m to
connect to the ACT receiver and AD-707 or AD-707a. While switching on the
receiver or antenna divider AD-707 or AD-707a, it is required to check the power
indicator of AT-70W. If the indicator does not light up, it means the built-in booster
is failed.
!
Adjust antenna's directional angel to proper position (see illustrations below) for
best performance result.
!
Set the base on any 35mm tripod or on top of MIPRO's MS-90 wall-mounting kit.
When done, tighten the knob (see illustrations below)
This product has following accessories:
1. User Guide x 1
Part Names and Functions
Setup Instruction
(Setup on to of MS-90 wall-mounting kit)
(Figure 2)
(Setup on a 35mm microphone tripod)
(Figure 1)
Notes
1
2
3
3
1
1
1
1
RX Antenna Cable Connector: The connector is installed with a 12dB-booster. It
is needed to have at least 20m antenna cable and connected to the receivers or
antenna dividers which offer 8V DC output power.
Power LED Indicator: The LED light with the 8V DC power input from receivers
and the booster will be started at the same time.
TX/RX Antenna Cable Connector: Transmission output or antenna input
connector, 0dB gain, can be connected with maximum 20m cable or antenna to
transmitters or receivers.
Swivel Adapter Bracket: Can be setup on any 35mm tripod or mounted on to
MIPRO's MS-90 wall-mounting kit.
1
2
3
4
Wideband Transmitting & Receiving Omni-Directional Antenna
Wideband Transmitting & Receiving Omni-Directional Antenna
1
2
3
4
TX / RX
RX Only
BOOSTER ACTIVE