JUNG R AN LS 914 WW RAN LS 914 WW Product Datasheet

Product codes
RAN LS 914 WW
Page of 2
ALBRECHT JUNG GMBH & CO. KG
Volmestraße 1
58579 Schalksmühle
Telefon +49 (0) 23 55/80 60
Telefax +49 (0) 23 55/80 6189
E-Mail kundencenter@jung.de
Radio
Product data sheet
Reference number
R AN LS 914 WW
Stereo radio
for LS range
screw fixing only, without claws
The device can be installed into frames of the LS range (up to 5-gang) and Flat Design (up
to 3-gang).
installation in 2- to 3-gang surface caps of the LS range is possible
Cover kit for vertical and horizontal installation included
Intended use
- Installation in two flush-type boxes in accordance with EN 49073 (recommendation:
deep boxes)
- For vertical and horizontal installation
- FM reception in the frequency range 87.5 MHz to 108 MHz
 
Product characteristics
- Stereo reception
- Connection terminal for additional external loudspeaker ref.-no.: LSM .. 4 .. (right
stereo channel)
- Automatic recognition of the second loudspeaker
- Automatic switching from mono to stereo operation when there is sufficient signal
strength and a second loudspeaker is connected
- Simple operation with additional status LED
  blue LED on: in operation
  blue LED flashes: sleep mode active
  red LED: preferred station
- High-quality tone and great loudspeaker dynamics
- Optimised acoustics through the use of a bass-reflex enclosure
- High reception quality
- Integrated FM antenna
- Automatic and manual station scan
- Non-volatile storage of 4 preferred stations (the stored stations are retained after
voltage failure)
- Sleep mode (switch off after approx. 30 minutes)
- Switching on/off via extension unit possible
- Switching on/off via potential-free contact A/B (e.g. switch or timer switch with
potential-free contact)
 
Extension unit function
The radio has two different extension inputs with floating or 230 V contacts. The
radio can thereby be switched on and off remotely.
The radio can for example be switched on together with the room lighting via the 230
V input of the power section. To do so, the switched phase is applied to the 230 V
extension input of the radio.
A switch can e.g. be connected to the floating input of the radio insert and used to
switch the radio on/off. The radio can also be used as a radio alarm clock through
the connection of a time switch with a make contact.
Spare part:
Cover kit for radio, vertical
Ref.-no.: R AN .. 914 TS ..
19.11.2014
1  2